To view the full catalogue details of each part, please click on the product image
TYPE | DESCRIPTION |
PART NUMBER |
||
|
||||
![]() |
This product is designed to protect the pipe from coming into direct
|
Figure 1A PVC |
||
![]() |
Designed to support non-insulated, stationary lines from above allowing for approximately 1" to 1 1/2" of vertical adjustment after the pipe is in place. The lower nut (not furnished) adjusts the pipe line to the proper elevation, the top nut (not furnished) prevents loosening due to vibration, and must be tightened securely to assure proper hanger performance. Rated Loads are for up to 650° F (343° C) for carbon steel. Maximum PVC temperature is 140° F (60° C). |
Figure 100PVC |
||
![]() |
The Figure 126LD is designed for the support or steadying of vertical PVC pipe risers for DWV applications. It is designed to hold tight to the pipe, transmitting the load to the structure through the ears on each end. When possible the clamp should be placed under a coupling, hub, or lugs welded to the pipe. For heavier loads please see our Figure 126. The Figure 126LD PVC is completely PVC coated. NOTE: This product is not designed to be supported with rods. |
Figure 126LD PVC |
||
![]() |
The Figure 126PVC is normally used for the support of uninsulated
|
Figure 126PVC |
||
![]() |
Our standard U-Bolts are recommended for use as supports or guides for piping. They are supplied with four hex nuts. The Figure 283PVC is for support of piping where contact with the pipe is not desired. Threads and nuts are not coated. |
Figure 283PVC |
||
![]() |
Designed for the support of non-insulated static pipe lines and to protect the pipe from coming into direct contact with the hanger by having the contact surface PVC coated. The swivel nut is knurled to provide a gripping surface when adjusting the pipe elevation. |
Figure 800PVC |